Light Panels User Manual
Mounting Your Panels
Prepare Your Surface
The Nanoleaf Light Panels should only be installed indoors and on a flat surface that can support the weight of the panels. Clean your surface to be free of dust, moisture and oil.
Using the Mounting Tape
Use the included Mounting Tape to securely attach the panels. We recommend using 3 pieces of Mounting Tape for each panel.
Mount Your First Panel
Designate a panel from your setup as the starting panel. Peel off the other side of the tape and press the panel firmly against the wall. Hold each corner for 30 seconds to ensure that your panel attaches firmly.
Make sure to leave end of the tape sticking out. This will allow you to safely remove them later from the wall.
Connecting the Controller
Connect your Controller into an available linker slot of the first panel. Plug the other end into a power source to ensure that your setup is on and properly connected as you continue to link your panels together.
Each standard 65W PSU supports up to 30 Light Panels (2W per panel).
Complete Your Setup
Continue to link each panel together and ensure that each panel lights up as you do so. Make sure the linkers are fully slotted into the linker slot, the panels should be aligned edge to edge.
Connecting Your Rhythm Module
The Rhythm Module is included with any purchase of the Nanoleaf Light Panels Smarter Kit. To connect the Rhythm, insert it into any available linker slot.
Using headphones but still want to see your panels react to music? Use a 3.5 mm audio cable and splitter to connect the Rhythm to an audio source. Audio cables and splitters do not come with any Nanoleaf products.
Need to Dismount Your Light Panels?
With one hand on the Light Panels, use your other hand to pull the ends of tape along the wall. Do not pull perpendicularly or at any other angle, otherwise, you may damage your wall. Continue removing the tape from each panel until they are all safely removed.