Sense+ Smart Switch User Manual

Top Button:

Turns your lights on

Bottom Button:

Turns your lights off

Middle Buttons:

Increase or decrease brightness by 15%

Left Side Button (Configurable):

Cycles through a sequence of white lighting temperatures ranging from warmest to coolest white.

Right Side Button (Configurable):

Cycles through a sequence of standard colours

Each side button can to be configured to 3 different actions and triggered on a:

• Single Press
• Double Press
• Long Press

The following actions are supported and can be mapped to your side buttons via the Nanoleaf App.

Cycle White Temperature:

Advance through a sequence of white lighting temperatures ranging from warmest to coolest white.

Cycle Colour:

Advance through a sequence of standard colours.

Set Colour:

Display a single colour of your choice.

Set Brightness:

Change brightness to a specified level of your choice.

Set Scene:

Display an animated Scene of your choice

The two side buttons can also be configured to trigger your favourite smart home routines via Matter (Early Access). You can enable Matter for a single side button (left or right) or both in the Nanoleaf App.

Side buttons connected to Matter must be configured directly in the respective Smart Home Ecosystem Apps. Actions and triggers supported are determined by the ecosystem, not Nanoleaf. You will not be able to edit the actions of any Matter-enabled side buttons on the Nanoleaf App.

Matter (Early Access) support is dependent on the individual smart home ecosystems.

To use Matter, you will require:

• A thread border router
• A Matter compatible hub

To enable Matter for your Switch:

• Go to your Control Group Settings under the (•••) “More” tab, and select the switch you would like to enable Matter for
• Select whether you would like to enable Matter for the left or ride side button
• Pair your device with your desired smart home ecosystem app
• Configuration of your Matter-enabled side buttons will now be done directly within your smart home ecosystem app

The Sense+ Smart Wireless Switch has built-in motion and daylight sensors.

1. Motion Sensors: Lights turn on when motion is detected.
2. Daylight Sensors: Lights remain off when bright daylight is detected.

You can set Sense+ (your sensors) to be ON, OFF, or PAUSED.

1. Sense+ ON: Your sensors default to your preset daylight / motion sensor settings.
2. Sense+ OFF: All sensors are turned off.
3. Sense+ PAUSED: All sensors are turned off temporarily until the user resumes it on the Nanoleaf App or by single pressing the physical ON or OFF buttons on the switch.

Tip: Pausing Sense+

Pausing Sense+ can be done via the Nanoleaf App or directly on the switch by holding (long press for 2s) the ON or OFF buttons.

This is ideal for situations such as:

1. Keeping your lights OFF while you watch a movie
2. Keeping your lights ON while you sit to work or read
3. Keeping your lights ON while you take a super long relaxing shower