Una API de red local diseñada para ampliar tu experiencia con el producto. Integra tu configuración con los dispositivos y los servicios de terceros y habilita un control más granular del hardware.
Elements User Manual
Mounting Your Elements
Prepara la superficie
The Nanoleaf Elements should only be installed indoors and on a flat surface that can support the weight of the panels. Clean your surface to be free of dust, moisture and oil (1.1). The included Mounting Tape is NOT recommended for textured, porous, popcorn, and ceiling surfaces (ie. wallpaper or brick walls).
Prepare Your First Panel
Diseña un panel de tu espacio como el panel de inicio. Coloca todos los conectores necesarios antes de colocar cualquier panel en la pared.
Connect the Controller & PSU
Conecta el controlador y la fuente de alimentación en las ranuras del conector disponibles del primer panel. Conecta el otro extremo de la fuente de alimentación a una fuente de alimentación para asegurarte de que tu espacio esté encendido y conectado correctamente mientras continúas conectando los paneles.
How many PSUs do I need?
Cada fuente de alimentación estándar de 42 W admite hasta 22 paneles Elements (2 W por panel). Cada controlador admite hasta 80 paneles de Elements. Usa nuestra calculadora de fuente de alimentación para las instalaciones grandes.
PSU calculatorCalculadora de fuente de alimentación
42W: One (1) 42W Power Supply Unit comes with any Nanoleaf Elements Starter Kit.
75W: For optimal performance, do not use both 42W and 75W Power Supplies in the same Nanoleaf setup.
Coloca tus paneles
Remove the protective liner from the tape and position your panel into place. Mount your panel by applying strong pressure to the center (this should be where the Mounting Plate is on the reverse side). Make sure to rub your fist in a circular motion for 30 seconds to avoid any falling panels.
Make sure to leave end of the tape sticking out. This will allow you to safely remove them later from the wall.
Completa tu espacio
Sigue agregando tus paneles y asegúrate de que los conectores estén completamente colocados en la ranura del conector. Los paneles deben estar alineados de borde a borde y deben iluminarse a medida que vas agregando cada panel.
Si deseas colocar paneles en el techo u otras superficies en ángulo, te recomendamos que utilices tornillos en lugar de la cinta para que te asegures de que la instalación quede bien sujeta.
- Mark up where your anchors will go. Position a Mounting Plate in place and mark up the 2 holes with a pencil.
- Install anchors (may need to drill a pilot hole).
- Fasten Mounting Plate to anchors with screws.
- Once secured, attach the panel to the Mounting Plate.
¿Quieres añadir una cinta nueva?
When you need to attach a replacement tape to your Mounting Plate, make sure the tape is placed between the two holes. Leave end of the tape sticking out. This will allow you to safely remove them later from the wall. Visit our shop for additional Mounting Tapes.
¿Necesitas retirar los Elements?
Gently snap off the panel from the wall. The Mounting Plate will remain on the wall. With one hand on the Mounting Plate, use your other hand to pull the end of tape along the wall. Do not pull perpendicularly or at any other angle, otherwise, you may damage your wall.
¡Añade a tu obra maestra!
Vuélvete aún más creativo y haz crecer tu espacio con los paquetes de expansión.
GET ONE TODAY