Canvas User Manual

The Nanoleaf Canvas should only be installed indoors and on a flat surface that can support the weight of the panels. Clean your surface to be free of dust, moisture and oil. The included Mounting Tape is NOT recommended for textured, porous, popcorn, and ceiling surfaces (ie. wallpaper or brick walls).

Use the included Mounting Tape to securely attach the panels. We recommend using 3 pieces of Mounting Tape for each panel.

Seleziona un pannello del tuo set come pannello di partenza. Rimuovi l’altro strato del nastro e attacca il pannello al muro esercitando una pressione decisa. Premi gli angoli per circa 30 secondi l’uno per assicurarti di aver attaccato correttamente il pannello.

Connect your Controller into an available linker slot of the first panel. Plug the other end into a power source to ensure that your setup is on and properly connected as you continue to link your panels together.

Continua a collegare tutti i pannelli ed assicurati che ciascun pannello si accenda correttamente. Assicurati che i connettori siano ben inseriti nei relativi alloggi, i pannelli dovrebbero essere allineati margine contro margine.

If you want to mount panels on the ceiling or other angled surfaces, we recommend using screws instead of tape to make sure your installation is securely attached. Purchase a Canvas Screw Mount Kit, available on the Nanoleaf Shop and follow these instructions:

• On the floor align the Mounting Plates you plan to place together and match the yellow lines so they are adjacent. Then press on the flaps to attach the Mounting Plates together.
• When you finish connecting all the Mounting Plates in your layout, cut off the unused flaps around the edges.
• Place the Rigid Linkers where the Mounting Plates line up together. This is where the panels would usually connect together as well if you did a normal adhesive installation.
• Hold the layout (which you created with the Mounting Plates) in place on the wall and with a pencil mark where your anchors will go.
• Drill a pilot hole and instal the anchors.
• Fasten the Mounting Plates to the anchors with screws.
• Once secured, attach the panel to the Mounting Plate. You’ll need to line the linker slots on the panels with the Rigid Linkers you placed earlier. Press down on each corner until it clicks in place.
• Once the Power Supply is connected you can begin to enjoy your fabulous screw mounted layout!

With one hand on the Canvas, use your other hand to pull the ends of tape along the wall. Do not pull perpendicularly or at any other angle, otherwise, you may damage your wall. Continue removing the tape from each panel until they are all safely removed.