本地網絡 API 設計為拓展您的產品體驗。透過第三方裝置和服務整合您的安裝，然後啟用硬件上更多的精緻控制。
Elements User Manual
Mounting Your Elements
Video tutorial for mounting
1
準備處理安裝表面
The Nanoleaf Elements should only be installed indoors and on a flat surface that can support the weight of the panels. Clean your surface to be free of dust, moisture and oil (1.1). The included Mounting Tape is NOT recommended for textured, porous, popcorn, and ceiling surfaces (ie. wallpaper or brick walls).
2
Prepare Your First Panel
安裝時指定一塊燈板作為起始燈板。正在連接控制器和電源
3
Connect the Controller & PSU
將您的控制器和電源連接至第一塊燈板可用的連接口。將電源另一端插上電源，以便確保您的安裝已開啟並正確連接，這樣您可以繼續連接燈板。
How many PSUs do I need?
每個標準的 42W 電源最多支援 22 塊 Elements 燈板（每塊燈板為 2W）。一個控制器最多支援 80 塊 Elements 燈板。有關大型安裝，請查看我們的電源計算器。
PSU calculator電源計算器
42W: One (1) 42W Power Supply Unit comes with any Nanoleaf Elements Starter Kit.
75W: For optimal performance, do not use both 42W and 75W Power Supplies in the same Nanoleaf setup.
4
安裝您的燈板
Remove the protective liner from the tape and position your panel into place. Mount your panel by applying strong pressure to the centre (this should be where the Mounting Plate is on the reverse side). Make sure to rub your fist in a circular motion for 30 seconds to avoid any falling panels.
Note
Make sure to leave end of the tape sticking out. This will allow you to safely remove them later from the wall.
5
完成您的安裝
繼續添加您的燈板，確保連接片完全卡入連接口。燈板應該邊對邊對齊，並且應該在添加每個燈板時亮起。
Screw Mounting Your Panels on the Ceiling or Angled Surfaces
如果要將面板安裝在天花板或其他傾斜的表面上，建議使用螺絲代替膠帶，以確保安裝牢固。
- Mark up where your anchors will go. Position a Mounting Plate in place and mark up the 2 holes with a pencil.
- Instal anchors (may need to drill a pilot hole).
- Fasten Mounting Plate to anchors with screws.
- Once secured, attach the panel to the Mounting Plate.
添加新膠紙？
When you need to attach a replacement tape to your Mounting Plate, make sure the tape is placed between the two holes. Leave end of the tape sticking out. This will allow you to safely remove them later from the wall. Visit our shop for additional Mounting Tapes.
需要拆卸您的 Elements？
Gently snap off the panel from the wall. The Mounting Plate will remain on the wall. With one hand on the Mounting Plate, use your other hand to pull the end of tape along the wall. Do not pull perpendicularly or at any other angle, otherwise, you may damage your wall.
加入您的創意！
透過智能燈板擴充裝，發揮更多創意並使您的安裝更具變化。
GET ONE TODAY
