This website uses first and third party cookies to personalise your experience, analyse web traffic data, and optimise performance. We never sell your data to third parties. Privacy Policy.
- Product Setup
- Problems & Solutions
Solar Garden Lights User Manual
Installation
- Assemble your main Solar Garden Light piece. Use the long or short connector depending on the height you prefer to attach the Solar Garden Light stake. Note
Not sure which stake to use? Tip: The Solar Garden Light stake is bigger than the Solar Panel stake! You can also refer back to the Component Glossary.
Heads up: Your long connector may come pre-attached to a Solar Garden Light stake. You can easily separate these if you would like to use a short connector instead.
- Attach the Solar Panel stake to the Solar Panel. Adjust the angle of your Solar Panel and turn the knob clockwise to tighten and secure it in place.
- Connect your main Solar Garden Light piece to your Solar Panel. Keep twisting the cap until it covers all the grooves on the Solar Panel cable connector.
- Adjust the stems of your lights to fan out in the way you desire. Only bend the bottom half of the stems closer to the bottom to avoid damaging the lights.
- Insert your fully assembled & connected Solar Garden Lights and Solar Panel into the ground. Make sure to place your solar panel in an unobstructed area where it will receive direct sunlight for at least 6-8 hours daily.
- Press the green power button on the solar panel to turn on the lights. You must do this before you can use the included remote.
Important
The Solar Garden Lights will not turn on if it is in daylight or bright ambient light. If you power it on in daylight, it will flash once before turning back off. Your lights will turn on automatically at night when it gets dark.
OPTIONAL: Mounting Your Solar Panel
Instead of just inserting your Solar Panel into the ground, you can also mount it onto a fence or wall with the provided screws.
- On this page
- Installation
- OPTIONAL: Mounting Your Solar Panel