Lines User Manual

Nanoleaf Lines should only be installed indoors and on a flat surface that can support the weight of the Lines. Clean your surface to be free of dust, moisture and oil. The included Mounting Tape is NOT recommended for textured, porous surfaces (ie. wallpaper or brick walls), popcorn walls /ceilings, and mirrors. See detailed guide for ceiling installations here.

Design your layout on a table or the floor. Once you are happy with your design, secure your Lines 6090 Degrees with the 6090 Degree Connector Caps.

Plug it into power to make sure your Lines turn on and are working properly.

Grab a friend to help with mounting your layout (4.1). For the best results, mount your layout all at once. For larger designs, mount in sections; be sure to mount closed-loop layouts together (triangles, hexagons, etc.). Carefully lift up your Lines 6090 Degrees layout and peel off the backing of the Mounting Tape. Press each of the Mounting Connectors against the wall for 30 seconds to secure your layout to the wall (4.2)

For a more secure installation, including for your ceiling instals, use the screw-mount solution (Screws not included).

Mount your Lines design to the ceiling first using the included Mounting Tape. Remove the light lines then carefully pull Mounting Connectors off to reveal the Mounting Plates which should be still adhered to the ceiling(5.1). Mark the screw holes (5.2) and then remove the mounting plate (5.3). See below how to safely remove Mounting Plates. Drill pilot holes and instal anchors. Please proceed with extra caution for hole alignment, large screw mount tolerance offset may lead to disruption of closed loop layout assemblies (5.4). Fasten Mounting Plate to anchors with screws (5.4). Once secured, attach the light lines and Mounting Connectors back onto the Mounting Plate.

Gently snap off the Connector Caps, then gently remove the light lines from the Mounting Connectors (1). Carefully pull the Mounting Connectors away from the attached surface (2). The Mounting Plate will remain adhered to the wall. With one hand on the Mounting Plate, use your other hand to pull the end of the exposed tape along the wall until fully removed (3).