Nanoleaf Lines User Manual - Mounting Your Lines

Table des matières

Configuration du produit
Problèmes et solutions

Montez vos Lines

Sélectionner un produit :

Lines 60 Degrees Lines 90 Degrees

Tutoriel vidéo pour le montage

Préparez la surface

Nanoleaf Lines should only be installed indoors and on a flat surface that can support the weight of the Lines. Clean your surface to be free of dust, moisture and oil. The included Mounting Tape is NOT recommended for textured, porous surfaces (ie. wallpaper or brick walls), popcorn walls /ceilings, and mirrors. See detailed guide for ceiling installations here.

Créez votre configuration

Dessinez votre configuration sur une table ou sur le sol. Lorsque vous êtes satisfait(e) de votre design, fixez vos Lines à 6090 degrés à l’aide des capuchons de connecteur à 6090 degrés.

Remarque

Le capuchon du contrôleur avec les boutons peut être fixé à n’importe quel connecteur.

Connectez l’alimentation électrique

Branchez sur le secteur pour vous assurer que vos Lines s’allument et fonctionnent correctement.

Combien de blocs d’alimentations me faut-il ?

Each standard 42W PSU supports up to 18 Lines 6090 Degrees (2W per line). You can connect up to 250 Lines in one layout to be controlled with a singular Controller Cap. Please check out our PSU Calculator for large installations.

Montez vos Lines

Grab a friend to help with mounting your layout (4.1). For the best results, mount your layout all at once. For larger designs, mount in sections; be sure to mount closed-loop layouts together (triangles, hexagons, etc.). Carefully lift up your Lines 6090 Degrees layout and peel off the backing of the Mounting Tape. Press each of the Mounting Connectors against the wall for 30 seconds to secure your layout to the wall (4.2)

Remarque

Besoin de plus de bandes adhésives de montage ? Achetez-en plus ici

Installation au plafond

Pour une installation plus sûre, y compris pour vos installations au plafond, utilisez la solution de montage à vis (vis non incluses).

Remarque

La solution de montage par vis est conçue pour les surfaces/plafonds LISSES uniquement.

Mount your Lines design to the ceiling first using the included Mounting Tape. Remove the light lines then carefully pull Mounting Connectors off to reveal the Mounting Plates which should be still adhered to the ceiling(5.1). Mark the screw holes (5.2) and then remove the mounting plate (5.3). See below how to safely remove Mounting Plates. Drill pilot holes and install anchors. Please proceed with extra caution for hole alignment, large screw mount tolerance offset may lead to disruption of closed loop layout assemblies (5.4). Fasten Mounting Plate to anchors with screws (5.4). Once secured, attach the light lines and Mounting Connectors back onto the Mounting Plate.

Vous souhaitez démonter vos Lines ?

Gently snap off the Connector Caps, then gently remove the light lines from the Mounting Connectors (1). Carefully pull the Mounting Connectors away from the attached surface (2). The Mounting Plate will remain adhered to the wall. With one hand on the Mounting Plate, use your other hand to pull the end of the exposed tape along the wall until fully removed (3).

Remarque

Do NOT pull perpendicular from the wall or at any other angle, otherwise, you may damage your wall (2).